|
|
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY FL-9 < REMOVAL AND INSTALLATION > C D E F G H I J K L M A FL N P O • Raise main fuel level sensor unit, fuel filter and fuel pump assembly, and disconnect fuel hose connector (push in tabs • Raise and release sub fuel level sensor unit to remove. INSTALLATION Note to the following, and install in the reverse order of removal. Main and Sub Fuel Level Sensor Unit 1. Install new seal packing to fuel tank without any twist. 2. Connect fuel hose connector (push in until it stops) and sub fuel 3. Align the direction mark on main fuel level sensor unit, fuel filter CAUTION: • Never allow seal packing to drop. 4. Install retainer for main fuel level sensor unit, fuel filter and fuel CAUTION: Install retainer horizontally. Quick Connector Connect quick connector as follows: 1. Check the connection for damage or any foreign materials. 2. Align the connector with the tube, then insert the connector straight into the tube until a click sound is 3. After connecting, check that the connection is secure by following method. SBIA0396E SBIA0398E SBIA0397E SBIA0411E Revision: 2011 November 2011 MURANO |