|
|
TROUBLE DIAGNOSIS BRC-19 [ABS] C D E G H I J K L M A B BRC Revision: 2005 August 2005 Murano Control Unit Input/Output Signal Standard AFS0018R REFERENCE VALUE FROM CONSULT-II CAUTION: The display shows control unit calculation data, so a normal value might be displayed even in the Note 1: Confirm tire pressure is normal. Monitor item Display content Data monitor Check item Condition Reference value in normal operation FR RH SENSOR Wheel speed Vehicle stopped 0 [km/h] BRC-30, "Inspection 1 Vehicle running (Note 1) Almost in accor- ± 10 %) BATTERY VOLT Battery voltage sup- Ignition switch ON 10 - 16 V STOP LAMP SW Brake pedal operation Brake pedal depressed ON – Brake pedal not depressed OFF ABS WARN LAMP ABS warning lamp ON ABS warning lamp ON ON – ABS warning lamp OFF OFF MOTOR RELAY Operation status of Ignition switch ON or engine OFF BRC-35, "Inspection 5 Ignition switch ON or engine ON ACTUATOR RLY Actuator relay opera- Vehicle stopped (Ignition OFF BRC-35, "Inspection 5 Vehicle stopped (Engine run- ON FR LH IN SOL Solenoid valve opera- Actuator (solenoid) is active ON BRC-34, "Inspection 3 When actuator (solenoid) is OFF ABS FAIL SIG Fail signal status ABS fail ON ABS system EBD normal OFF DECEL G-SEN Longitudinal accelera- Vehicle stopped Approx. 0G BRC-38, "Inspection 7 G Vehicle running -1.7 - +1.7G EBD WARN LAMP Brake warning lamp on Brake warning lamp ON ON – Brake warning lamp OFF OFF EBD SIGNAL EBD operation EBD active ON EBD not active OFF ABS SIGNAL ABS operation ABS active ON ABS not active OFF |