|
|
LAN-222 [CAN] CAN SYSTEM (TYPE 6) Revision; 2004 April 2003 Murano 10. CHECK HARNESS FOR SHORT CIRCUIT 1. Disconnect ABS actuator and electric unit (control unit) connector and IPDM E/R connector. 2. Check continuity between IPDM E/R harness connector E9 ter- OK or NG OK >> GO TO 11. NG >> Check the following harnesses. If any harness is dam- aged, repair the harness. ● Harness between IPDM E/R and ABS actuator and ● Harness between IPDM E/R and harness connector 11. CHECK HARNESS FOR SHORT CIRCUIT Check continuity between IPDM E/R harness connector E9 termi- OK or NG OK >> GO TO 12. NG >> Check the following harnesses. If any harness is dam- aged, repair the harness. ● Harness between IPDM E/R and ABS actuator and ● Harness between IPDM E/R and harness connector E105. 12. ECM/IPDM E/R INTERNAL CIRCUIT INSPECTION Check components inspection. Refer to LAN-223, "ECM/IPDM E/R INTERNAL CIRCUIT INSPECTION" OK or NG OK >> Connect all the connectors and diagnose again. Refer to . NG >> Replace ECM and/or IPDM E/R. 48 (L) - 49 (Y) : Continuity should not exist. LKIA0030E 48 (L) - Ground : Continuity should not exist. 49 (Y) - Ground : Continuity should not exist. LKIA0036E |