|
|
B2602 SHIFT POSITION SEC-295 < COMPONENT DIAGNOSIS > [WITHOUT INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P YES >> GO TO 4. NO >> GO TO 3. 3. CHECK CONTROL DEVICE POWER SUPPLY CIRCUIT 1. Disconnect BCM connector. 2. Check continuity between control device (detention switch) harness connector and BCM harness connec- 3. Check continuity between control device (detention switch) harness connector and ground. Is the inspection result normal? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation" NO >> Repair or replace harness or connector. 4. CHECK CONTROL DEVICE CIRCUIT 1. Disconnect BCM connector and IPDM E/R connector. 2. Check continuity between control device (detention switch) harness connector and BCM harness connec- 3. Check continuity between control device (detention switch) harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace harness or connector. 5. CHECK CONTROL DEVICE (DETENTION SWITCH) SEC-293, "Component Inspection" . Is the inspection result normal? YES >> GO TO 6. NO >> Replace control device. Refer to TM-165, "Removal and Installation" 6. CHECK INTERMITTENT INCIDENT GI-40, "Intermittent Incident" . >> INSPECTION END Control device (detention switch) BCM Continuity Connector Terminal Connector Terminal M57 8 M122 96 Existed Control device (detention switch) Ground Continuity Connector Terminal M57 8 No existed Control device (detention switch) BCM Continuity Connector Terminal Connector Terminal M57 9 M122 99 Existed Control device (detention switch) Ground Continuity Connector Terminal M57 9 No existed Revision: 2008 October 2009 Murano |