|
|
B2108 STEERING LOCK RELAY SEC-103 < COMPONENT DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P B2108 STEERING LOCK RELAY Description INFOID:0000000003375710 The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication. DTC Logic INFOID:0000000003375711 DTC DETECTION LOGIC NOTE: DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Press the push-button ignition switch under the following conditions and wait for at least 1 second. - Selector lever is in the P or N position. - Do not depress brake pedal. 2. Check “Self diagnostic result” with CONSULT-III. Is DTC detected? YES >> Go to SEC-103, "Diagnosis Procedure" . NO >> INSPECTION END Diagnosis Procedure INFOID:0000000003375712 1. CHECK STEERING LOCK RELAY Check voltage between IPDM E/R harness connector and ground. Is the inspection normal? YES >> GO TO 2. NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" . 2. CHECK INTERMITTENT INCIDENT GI-40, "Intermittent Incident" . >> INSPECTION END DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2108 STRG LCK RELAY ON IPDM E/R detects that the relay is stuck at ON posi- IPDM E/R (+) (–) Condition Voltage (V) (Approx.) IPDM E/R Connector Terminal E10 11 Ground Ignition switch A few seconds after Battery voltage Ignition switch Press the push-button Battery voltage Ignition switch ACC or ON 0 Revision: 2008 October 2009 Murano |