|
|
содержание .. 535 536 537 538 ..
DOOR LOCK ACTUATOR DLK-489 < DTC/CIRCUIT DIAGNOSIS > [TYPE 2] C D E F G H I J L M A B DLK N O P 3. Check continuity between BCM harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK BCM OUTPUT SIGNAL 1. Connect BCM connector. 2. Check voltage between BCM harness connector and ground. Is the inspection result normal? YES >> Check for internal short of rear door lock actuator. NO >> Replace BCM. Refer to BCS-121, "Removal and Installation" . REAR RH REAR RH : Component Function Check INFOID:0000000010717549 1. CHECK FUNCTION 1. Turn ignition switch ON. 2. Select “DOOR LOCK” of “BCM” using CONSULT. 3. Select “DOOR LOCK” in “ACTIVE TEST” mode. 4. Touch “ALL LOCK” or “ALL UNLK” to check that it works normally. Is the inspection result normal? YES >> Door lock actuator is OK. NO >> Refer to DLK-489, "REAR RH : Diagnosis Procedure" REAR RH : Diagnosis Procedure INFOID:0000000010717550 1. CHECK DOOR LOCK ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect rear door lock assembly RH connector. 3. Check voltage between rear door lock assembly RH harness connector and ground. BCM Rear door lock assembly LH Continuity Connector Terminal Connector Terminal B46 124 D85 2 Existed 125 1 BCM Ground Continuity Connector Terminal B46 124 Not existed 125 (+) (–) Condition Voltage BCM Connector Terminal B46 124 Ground Door lock and unlock switch Unlock 9 – 16 V 125 Lock (+) (–) Condition Voltage Rear door lock assembly RH Connector Terminal D105 5 Ground Door lock and unlock switch Lock 9 – 16 V 6 Unlock |