|
|
PB-86 < DTC/CIRCUIT DIAGNOSIS > C1BD6 DOOR SYSTEM C1BD6 DOOR SYSTEM DTC Description INFOID:0000000010833675 DTC DETECTION LOGIC POSSIBLE CAUSE • Harness or connector DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF >> GO TO 2. 2. CHECK DTC DETECTION With CONSULT 1. Turn the ignition switch OFF to ON. CAUTION: Be sure to wait for 10 seconds after turning ignition switch OFF or ON. 2. Push the parking brake switch. CAUTION: • Set the select lever in the P position. 3. Pull the parking brake switch. 4. Perform self-diagnosis for “EHS/PKB”. Is DTC “C1BD6” detected? YES >> Proceed to NO-1 >> To check malfunction symptom before repair: Refer to GI-44, "Intermittent Incident" . NO-2 >> Confirmation after repair: INSPECTION END Diagnosis Procedure INFOID:0000000010833676 1. ERFORM SELF-DIAGNOSIS (1) With CONSULT Perform self-diagnosis for “BCM”. Is DTC detected? YES >> Check the DTC. Refer to NO >> GO TO 2. 2. CHECK DATA MONITOR With CONSULT 1. Turn the ignition switch OFF to ON. CAUTION: Be sure to wait for 10 seconds or more after turning the ignition switch OFF. 2. Select “BCM” and “DATA MONITOR” according to this order. 3. Check the “DOOR STAT-DR” of monitor item. Refer to Is the inspection result normal? DTC Display Item (Trouble diagnosis content) Malfunction detected condition C1BD6 DOOR SW Door switch (driver side) signal is not input when door open or close. |