|
|
PB-62 < DTC/CIRCUIT DIAGNOSIS > C10C8 ELECTRIC PARKING BRAKE CONTROL MODULE • Set the select lever in the P position. 3. Pull the parking brake switch. 4. Perform self-diagnosis for “EHS/PKB”. Is DTC “C10C8” detected? YES (Type 1)>>Proceed to PB-62, "TYPE 1 : Diagnosis Procedure" . YES (Type 2)>>Proceed to PB-62, "TYPE 2 : Diagnosis Procedure" . YES (Type 3)>>Proceed to PB-62, "TYPE 3 : Diagnosis Procedure" . YES (Type 4)>>Proceed to PB-62, "TYPE 4 : Diagnosis Procedure" . YES (Type 5)>>Proceed to PB-63, "TYPE 5 : Diagnosis Procedure" . NO-1 >> To check malfunction symptom before repair: Refer to GI-44, "Intermittent Incident" NO-2 >> Confirmation after repair: INSPECTION END TYPE 1 TYPE 1 : Diagnosis Procedure INFOID:0000000010833650 1. REPLACE ELECTRIC PARKING BRAKE CONTROL MODULE Replace the electric parking brake control module even if other display than “C10C8” (CONTROL MODULE >> Replace the electric parking brake control module. Refer to PB-141, "Removal and Installation" TYPE 2 TYPE 2 : Diagnosis Procedure INFOID:0000000010833651 1. REPLACE ELECTRIC PARKING BRAKE CONTROL MODULE Replace the electric parking brake control module even if other display than “C10C8” (CONTROL MODULE µ C ERROR) is displayed in self-diagnosis for “EHS/PKB”. >> Replace the electric parking brake control module. Refer to PB-141, "Removal and Installation" TYPE 3 TYPE 3 : Diagnosis Procedure INFOID:0000000010833652 1. REPLACE ELECTRIC PARKING BRAKE CONTROL MODULE Replace the electric parking brake control module even if other display than “C10C8” (CONTROL MODULE >> Replace the electric parking brake control module. Refer to PB-141, "Removal and Installation" TYPE 4 TYPE 4 : Diagnosis Procedure INFOID:0000000010833653 1. ERASE SELF-DIAGNOSIS RESULT With CONSULT 1. Turn the ignition switch ON. 2. Erase self-diagnosis result for “EHS/PKB”. >> GO TO 2. 2. PERFORM WORK SUPPORT (1) With CONSULT Select “WORK SUPPORT” and “FINISH BRAKE PAD REPLACEMENT” according to this order. |