|
|
P0705 TRANSMISSION RANGE SENSOR A TM-303 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10D] C E F G H I J K L M A B TM N O P Is the inspection result normal? YES >> GO TO 10. NO >> Repair or replace malfunctioning parts. 8. CHECK R POSITION SW CIRCUIT (PART1) 1. Turn ignition switch OFF. 2. Disconnect TCM connector. 3. Check continuity between TCM harness connector terminals. Is the inspection result normal? YES >> GO TO 9. NO >> Repair or replace malfunctioning parts. 9. CHECK R POSITION SW CIRCUIT (PART 2) 1. Disconnect transmission range switch connector. 2. Turn ignition switch ON. 3. Check voltage between TCM harness connector terminal and ground. Is the inspection result normal? YES >> GO TO 10. NO >> Repair or replace malfunctioning parts. 10. CHECK TRANSMISSION RANGE SWITCH Check transmission range switch. Refer to TM-303, "Component Inspection" Is the check result normal? YES >> Check intermittent incident. Refer to GI-41, "Intermittent Incident" . NO >> Repair or replace malfunctioning parts. Component Inspection INFOID:0000000010589296 1. CHECK TRANSMISSION RANGE SWITCH Check continuity between transmission range switch connector terminals. TCM Continuity Connector Terminal F2 6 2 Not existed 4 5 7 + − Voltage (Approx.) TCM Connector Terminal F2 6 Ground 0 V Transmission range switch Condition Continuity Terminal 1 – 2 Manual lever: “P” and “N” positions Existed Other than the above Not existed 3 – 4 Manual lever: “P” position Existed Other than the above Not existed 3 – 5 Manual lever: “R” position Existed Other than the above Not existed |