|
|
Content .. 1826 1827 1828 1829 ..
BCS-38 < SYSTEM DESCRIPTION > DIAGNOSIS SYSTEM (BCM) *: For models without rear fog lamp, this item is displayed, but cannot be tested. HEADLAMP : CONSULT Function (BCM - HEAD LAMP) (Halogen Headlamp) INFOID:0000000010505171 WORK SUPPORT * 1 : For models without auto light system, this item is displayed, but cannot be used. * 2 : Factory setting DATA MONITOR NOTE: RR FOG LAMP* On Outputs voltage to turn the rear fog lamp ON. Off Stops the voltage to turn the rear fog lamp OFF. STOP LAMP 1 On Outputs voltage to turn the stop lamp RH ON. Off Stops the voltage to turn the stop lamp RH OFF. STOP LAMP 2 On Outputs voltage to turn the stop lamp LH ON. Off Stops the voltage to turn the stop lamp LH OFF. STOP LAMP 3 On Outputs voltage to turn the high-mounted stop lamp ON. Off Stops the voltage to turn the high-mounted stop lamp OFF. Test item Operation Description Service item Setting item Setting CUSTOM A/LIGHT SET- TING* 1 MODE 1* 2 Normal MODE 2 More sensitive setting than normal setting. (Turns ON earlier than normal op- MODE 3 More sensitive setting than MODE 2. (Turns ON earlier than MODE 2.) MODE 4 Less sensitive setting than normal setting. (Turns ON later than normal oper- TWILIGHT On MODE 1 NOTE: MODE 2 WIPER LINK MODE 1 NOTE: MODE 2 MODE 3 MODE 4 Monitor item [Unit] Description PUSH SW Indicates [On/Off] condition of push-button ignition switch ENGINE STATE Indicates [STOP/STALL/CRANK/RUN] condition of engine states VEH SPEED 1 Indicates [km/h] condition of vehicle speed signal from combination meter |