|
|
Content .. 1363 1364 1365 1366 ..
DOOR LOCK ACTUATOR DLK-729 < DTC/CIRCUIT DIAGNOSIS > [TYPE 5] C D E F G H I J L M A B DLK N O P Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK BCM OUTPUT SIGNAL 1. Connect BCM connector. 2. Check voltage between BCM harness connector and ground. Is the inspection result normal? YES >> Check for internal short of each door lock actuator. NO >> Replace BCM. Refer to BCS-135, "Removal and Installation" . REAR RH REAR RH : Component Function Check INFOID:0000000010672342 1. CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Door lock actuator is OK. NO >> Refer to DLK-725, "DRIVER SIDE : Diagnosis Procedure" . REAR RH : Diagnosis Procedure INFOID:0000000010672343 1. CHECK DOOR LOCK ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect rear door lock assembly RH connector. 3. Check voltage between rear door lock assembly RH harness connector and ground. Is the inspection result normal? YES >> Replace rear door lock assembly RH. NO >> GO TO 2. BCM Ground Continuity Connector Terminal B3 124 Not existed 125 (+) (–) Condition Voltage BCM Connector Terminal B3 124 Ground Door lock and unlock switch Unlock 9 – 16 V 125 Lock Monitor item Status DOOR LOCK ALL LOCK Door lock actuators LOCK ALL UNLOCK UNLOCK (+) (–) Condition Voltage Rear door lock assembly RH Connector Terminal D64 2 Ground Door lock and unlock switch Unlock 9 – 16 V 3 Lock |