|
|
Content .. 1323 1324 1325 1326 ..
DOOR LOCK STATUS INDICATOR DLK-569 < DTC/CIRCUIT DIAGNOSIS > [TYPE 4] C D E F G H I J L M A B DLK N O P DOOR LOCK STATUS INDICATOR Component Function Check INFOID:0000000010504772 1. CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT. 2. Select “DOOR LOCK IND” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Door lock status indicator is OK. NO >> Refer to DLK-569, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000010504773 1. CHECK DOOR LOCK STATUS INDICATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect indicator unit connector. 3. Check voltage between indicator unit harness connector and ground. Is the inspection result normal? YES >> Replace indicator unit. NO >> GO TO 2. 2. CHECK DOOR LOCK STATUS INDICATOR CIRCUIT 1. Disconnect BCM connector. 2. Check continuity between BCM harness connector and indicator unit harness connector. 3. Check continuity between BCM harness connector and ground. Is the inspection result normal? YES >> Replace BCM. Refer to BCS-135, "Removal and Installation" . NO >> Repair or replace harness. Monitor item Status DOOR LOCK IND ON Door lock status indicator Turns ON OFF Turns OFF (+) (–) Voltage Indicator unit Connector Terminal M4 5 Ground 9 – 16 V BCM Indicator unit Continuity Connector Terminal Connector Terminal M69 111 M4 5 Existed BCM Ground Continuity Connector Terminal M69 111 Not existed |