|
|
Content .. 1231 1232 1233 1234 ..
PRECAUTIONS DLK-201 < PRECAUTION > [TYPE 2] C D E F G H I J L M A B DLK N O P PRECAUTION PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT INFOID:0000000010434753 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along WARNING: Always observe the following items for preventing accidental activation. the event of a collision that would result in air bag inflation, all maintenance must be performed by • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser- vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: Always observe the following items for preventing accidental activation. ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with • When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service. Precaution Necessary for Steering Wheel Rotation After Battery Disconnect INFOID:0000000010479688 CAUTION: Comply with the following cautions to prevent any error and malfunction. power source to the OFF, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONSULT to perform self-diagnosis as a part of each function inspection after finishing work. If a DTC is detected, perform trouble diagnosis according to self-diagnosis results. For vehicle with steering lock unit, if the battery is disconnected or discharged, the steering wheel will lock and OPERATION PROCEDURE 1. Connect both battery cables. 2. Open driver door. 3. Turn the ignition switch to the ON position. 4. Turn the ignition switch to OFF position with driver door open. 5. Wait for 3 minutes or longer with driver door open. |