INPUT SIGNAL PROCEDURES
TSB Revision
SWS INPUT SIGNAL PROCEDURES
54Bc-19
NOTE: Also check joint connector D-01, junction block connec-
tors D-208, D-212 and intermediate connector E-11 for loose,
corroded, or damaged terminals, or terminals pushed back in
the connector. If joint connector D-01, junction block connector
D-208, D-212 or intermediate connector E-11 is damaged,
Repair or replace the damaged component(s) as described in
GROUP 00E, Harness Connector Inspection
P.00E-2
.
Q: Is the wiring harness between transmission range
switch connector C-04 (terminal 7) and the ignition
switch (IG1) in good condition?
YES : No action is necessary and testing is complete.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary. If the rear
wiper operates normally, it indicates that a correct "R"
position signal is sent from the transmission range
switch.
AC204170
CONNECTOR: D-01
AB
9 10
8
6 7
31 32
30
29
18 19 20 21
5
4
2
1
3
27
26
24
23
25
12 13 14 15 16 17
28
11
22
33
AC204191
CONNECTORS : D-208, D-212
D-208
AD
HARNESS SIDE
HARNESS SIDE
D-212
D-208
D-212
1
2
3
5
6
4
7 6 5
2 1
9 8
11 10
4 3
AC204176
CONNECTOR: E-11
AB
3
10
16
9
7 8
6
1
4
2
5
11
14
1213
15