|
|
The front doors or the liftgate is not fully closed. Do not hit the front/rear camera, front bumper, and door mirrors forcefully. The camera position or installation angle may shift. The cameras are of a waterproof structure. Do not disassemble, modify, or remove a camera. The camera cover is made of hard plastic, therefore do not apply oil film remover, organic solvents, wax, or coating agents. If any such agent gets on the camera cover, wipe it off Do not rub the camera lens forcefully, or clean it with an abrasive or hard brush. Otherwise, it could scratch the camera lens and negatively affect the images. Consult an Authorized Mazda Dealer for repair, painting, or replacement of the front/rear camera, front bumper and door mirrors. Heed the following cautions to assure that the 360°View Monitor operates normally. Do not modify the suspensions. Authorized Mazda Dealer for tire replacement. When the display is cold, images may leave trails or the screen might be darker than usual, making it difficult to check the vehicle surroundings. Always confirm the safety at the front The method for parking/stopping the vehicle using the 360°View Monitor differs depending on the road circumstances/conditions and the vehicle conditions. When and how much you NOTE If there are water droplets, snow, or mud on the camera lens, wipe it off using a soft cloth. If the area where the camera is installed, such as the liftgate or door mirrors, has been If the camera is subjected to excessive changes in temperature such as by pouring hot If the battery voltage is low, the screen might be temporarily difficult to view, however, When Driving i-ACTIVSENSE 4-168 CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27 |