|
|
232 4-3. Operating the lights and wipers The wipers can be used as intermittent windshield wipers, which operate regard- Press and hold until the AUTO mode indicator stops flashing. If is pressed and held until the AUTO mode indicator stops flashing again, it will return to its previous state. ■ The windshield wiper and washer can be operated when ■ Dripping prevention wiper sweep after a short delay to prevent dripping. ■ Effects of vehicle speed on wiper operation ● Intermittent windshield wipers interval changes when the vehicle is stopped. ● With low speed operation selected, wiper operation will be switched from low speed to intermittent operation only when the vehicle is stationary. ■ Raindrop sensor ● If AUTO mode is selected while the engine switch is in IGNITION ON mode, the wip- ers will operate once to show that AUTO mode is activated. ● If the temperature of the raindrop sensor is 185°F (85°C) or higher, or -22°F (-30°C) or lower, automatic operation may not occur. In this case, operate the wipers in any mode other than AUTO mode. Switching between the intermittent windshield wipers and rain-sensing ● The raindrop sensor judges the amount of raindrops. ate properly when sunlight from the rising or setting of the sun intermittently strikes the windshield, or if bugs etc. are present on the windshield. |