TEST
ACTION
APPLICABILITY
3
Remove the Driver Blend Door Motor from the vehicle. Rotate the blend door (door
only), this should rotate approximately 45 degrees from stop to stop.
Inspect the blend door linkage for excessive wear or missing linkage.
Were any mechanical problems found?
All
Yes
→
Repair or replace the blend door/linkage as necessary.
With the DRB, Reset Module after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
No
→
Replace the AZC Module.
With the DRB, Reset Module after repair/replacement is com-
pleted.
Perform BODY VERIFICATION TEST - VER 1.
287
HEATING & A/C
DRIVER BLEND DOOR RANGE TOO LARGE (ACTIVE) —
Continued