|
|
2 . If an obvious cause for an observed or reported symptom is found, correct the cause (if possible) before proceeding to the next step.
3 . If the cause is not visually evident, use the Jaguar approved diagnostic system or a scan tool to retrieve the fault codes before proceeding to the DTC Index, or the symptom chart if no DTCs are set. Symptom Chart Symptom (general)
Symptom (specific)
Possible source
Action
Non-Start
Engine does not crank
Security system /Immobiliser engaged Engine in shut-down mode ECM relay Battery Park/Neutral switch Starting system Harness Engine seized
Check that the security system is disarmed. Check for DTCs. For ECM relay tests, GO to Pinpoint Test G531330p32. For battery information, Battery For Park/Neutral tests, External Controls For starting system, For engine information, Engine
Engine cranks, but does not fire
Engine breather system disconnected/restricte Ignition system Fuel system Harness Crankshaft position (CKP) sensor ECM fault
Check the engine breather system, Engine Emission Control - VIN Range: G45704->G99999 For ignition system tests, Engine Ignition - VIN Range: G45704->G99999 For fuel system, Fuel Charging and Controls - VIN Range: G45704->G99999 For CKP tests, GO to Pinpoint Test G531330p17. Refer to the warranty policy and procedures manual if an ECM is suspect.
Engine cranks and fires, but will not start
Evaporative emissions purge valve Fuel pump For purge valve tests, Evaporative Emissions - VIN Range: G45704->G99999 For fuel pump circuit tests, |