|
|
Cylinder 6 ignition coil connector, harness side Battery
PI08, pin 03
Negative terminal
Cylinder 7 ignition coil connector, harness side Battery
PI05, pin 03
Negative terminal
Cylinder 8 ignition coil connector, harness side Battery
PI09, pin 03
Negative terminal
Is the resistance greater than 5 ohms? -> Yes REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTCs and test the system for normal operation.
-> No GO to Pinpoint Test G531328t6.
G531328t6 : CHECK THE IGNITION COIL SWITCHING CIRCUITS FOR HIGH 1. Disconnect the ECM electrical connector, PI300. 2. Measure the resistance between: Cylinder 1 ignition coil connector, harness side ECM connector PI300, harness side PI02, pin 04
Pin 61
Cylinder 2 ignition coil connector, harness side ECM connector PI300, harness side PI06, pin 04
Pin 60
Cylinder 3 ignition coil connector, harness side ECM connector PI300, harness side |