|
|
Pin 01
Injector body Pin 02
Injector body
Is either resistance less than 10,000 ohms? -> Yes INSTALL a new injector. Fuel Injectors (18.10.02) CLEAR the DTC and test the system for normal operation.
-> No GO to Pinpoint Test G240048t15.
G240048t15 : CHECK THE INJECTOR SUPPLY VOLTAGE 1. Key on, engine off. 2. Make sure the EMS relay is energized. 3. Measure the voltage between: Injector connector, harness side Battery
Pin 02
Negative terminal
Is the voltage less than 10 Volts? -> Yes REPAIR the circuit between the relevant injector harness electrical connector pin 02 and battery. This circuit includes fuse 13 of the front power distribution box and the EMS relay. For additional information, refer to the wiring diagrams. CLEAR the DTC and test the system for normal operation.
-> No GO to Pinpoint Test G240048t16.
G240048t16 : CHECK THE INJECTOR CONTROL CIRCUIT FOR SHORT CIRCUIT 1. Key off. 2. Measure the resistance between: Injector connector, harness side Battery
Pin 01
Negative terminal
|