|
|
G206886t6 : CHECK THE INJECTOR GROUND CIRCUIT FOR SHORT CIRCUIT 1. Measure the resistance between the relevant injector harness electrical connector (IL03 to IL08) pin 01 and GROUND. •
Is the resistance less than 10,000 ohms? -> Yes REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the system for normal operation.
-> No Contact dealer technical support for advice on possible ECM failure. PINPOINT TEST G206886p2 : DTC G206886t7 : CHECK THE FRP SENSOR SIGNAL CIRCUIT FOR HIGH 1. Turn the ignition switch to the OFF position. 2. Disconnect the battery negative terminal. 3. Disconnect the FRP sensor electrical connector, IL12. 4. Measure the resistance between IL12 pin 03 (U) and PI01 pin 73 (U). •
Is the resistance greater than 5 ohms? -> Yes REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the system for normal operation.
-> No GO to Pinpoint Test G206886t8.
G206886t8 : CHECK THE FRP SENSOR SIGNAL CIRCUIT FOR SHORT TO HIGH 1. Reconnect the battery negative terminal. 2. Turn the ignition switch to the ON position. 3. Measure the voltage between IL12 pin 03 (U) and GROUND. •
Is the voltage greater than 3 volts? -> Yes REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. |