G1043827t17 : CHECK THE BELT TENSION SENSOR
SUPPLY CIRCUIT TO THE PWS FOR SHORT TO
GROUND
1. Measure the resistance between SP33, pin 01 (Y) and GROUND.
•
Is the resistance less than 10,000 ohms?
-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR
the DTC. TEST the system for normal operation.
-> No
GO to Pinpoint Test G1043827t18.
G1043827t18 : CHECK THE BELT TENSION SENSOR
SUPPLY CIRCUIT TO THE PWS FOR SHORT TO
POWER
1. Measure the voltage between SP33, pin 01 (Y) and GROUND.
•
Is the voltage greater than 3 volts?
-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR
the DTC. TEST the system for normal operation.
-> No
INSTALL a new belt tension sensor. CLEAR the DTC. Allow a self-test to complete. TEST
the system for normal operation. if the fault reoccurs, contact dealer technical support for
advice on possible weight sensor failure.
PINPOINT TEST G1043827p4 : DTC
B2290, B2909: FLASH CODE 17:
TRANSDUCER AND/OR CIRCUIT
MALFUNCTION, OCM AND/OR
CIRCUIT MALFUNCTION
G1043827t19 : CHECK THE A PILLAR TRANSDUCER
CIRCUIT FOR SHORT CIRCUIT