|
|
Content .. 1311 1312 1313 1314 ..
-> No The AUX1 circuit checks out. G240121t36 : CHECK THE L3 CIRCUIT FROM RC03 TO RC04 FOR 1. Disconnect intermediate connector, RC04. 2. Measure the resistance between RC03, pin 19 (YG) and RC04, pin 19 (YG). •
Is the resistance greater than 5 ohms? -> Yes INSTALL a new harness between RC03 and RC04. TEST the system for normal operation.
-> No INSTALL a new harness between RC03 and TL86. TEST the system for normal operation. PINPOINT TEST G240121p7 : CHECK G240121t37 : CHECK THE CONT R1 OUTPUT FROM THE CONTROL PANEL 1. Disconnect the control panel electrical connector, RC03. 2. Turn the video/audio tester ON, and to the TEST position by holding in the TEST button while selecting PAL or NTSC. The blue and red LEDs will illuminate. 3. Make sure both screens are selected on the control panel. 4. Turn the ignition switch to the ON position. 5. Measure the voltage between RC03, pin 11 (probing INTO the control panel) and GROUND. •
Is the voltage 5 volts? -> Yes GO to Pinpoint Test G240121t38.
-> No INSTALL a new control panel, Rear Passenger Entertainment Control Panel TEST the system for normal operation. G240121t38 : CHECK THE CONT R2 OUTPUT FROM THE CONTROL PANEL 1. Measure the voltage between RC03, pin 10 (probing INTO the control panel) and GROUND. •
Is the voltage 0 volts? |