CAUTION
Be very careful when draining
the engine oil as it may be hot
enough to burn you.
Dropped oil may cause a fire.
Wipe and clean each part in
the engine room.
the oil level.
3. If a badly contaminated engine
oil is obvious when checking the
oil level, replace the engine oil ir鄄
respective of the service intervals.
OIL FILTER
荫 The engine oil and filter should
be changed at those intervals
specified in the maintenance
schedule. If the car is being driven
in severe conditions, more frequent
oil and filter changes are required.
荫 If the filter is blocked the warn鄄
ing light is on and if the oil pres鄄
sure is low the buzzer sounds at
the same time. Replace it inde鄄
pendent of the mileage.
荫 An element assembly cannot be
reused.
Replacement of filter type
1. Put an empty container below
the oil filter drain hose. Remove the
air bleeding plug and drain the
engine oil out.
2. Disassemble the case by pulling
the center bolt on the oil filter out
and remove the element.
3. Use the genuine parts when you
assemble. Replace the element
and rub packing of the case si鄄
multaneous. Apply engine oil on
the rub packing before assem鄄
bling. Tighten the center bolt with
specified torque 5.5依0.5 kg.m.
4. When you replace only the oil fil鄄
ter replenish the engine oil.
5. Crank the engine and check the
oil leakage and the oil level later.
102
VEHICLE MAINTENANCE REQUIREMENTS
WINDSHIELD WASHER FLUID
LEVEL
Check to ensure that windshield
washer fluid is at a proper level.
Operation of wipers
荫 Push the knob to check that the
windshield washer fluid is sprayed
at the correct position.
荫 Turn the lever and check the
wipers for proper operation.
TURBOCHARGER
Principle of turbo charger operation
Turbo engine is a device that pro鄄
duces more power by supplying
sufficient air into the combustion
chamber by using the energy of
exhaust gas is usually wasted in
the general engine.
The exhaust gases are accelerated
in the turbine housing and directed
onto the turbine wheel to turn it.
This spins the compressor wheel,
103
NOTE:
Be sure to operate the wind鄄
shield washer before the wipers
are operated.
Do not operate the wipers on
dry glass,This can result in
more rapid wear of the wiper
blades and may scratch the
glass.