|
|
6E1–383 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION 5. Remove the retaining bolt and sensor from the engine block. NOTE: Use caution to avoid any hot oil that might drip 0013 Installation Procedure 1. Install the crank shaft position sensor to its position. Mechanical Section. 0013 3. Reinstall the power steering pump and bracket to the engine. 014RX006 4. Reinstall the accessory drive belt. 014RX003 IMPORTANT: PCM must re–learn Crankshaft Position when the CKP sensor is replaced. Refer to CKP sensor |