|
|
ENGINE CONTROL SYSTEM (4JK1/4JJ1) 6E-187 DTC P0567 (Flash Code 517) Circuit Description The cruise control keeps the vehicle speed at a driver's Condition for Running the DTC • The ignition switch is ON. • The engine is running. Condition for Setting the DTC Either of following condition is met: • The ECM detects that the cruise resume/ accel. switch signal is repeated ON/ OFF continuously • The ECM detects that the cruise resume/ accel. switch signal is stuck at the ON position (high Action Taken When the DTC Sets • The ECM will not illuminate the MIL or SVS lamp. Refer to DTC Type Definitions for Action Taken • The ECM inhibits cruise control. Condition for Clearing the DTC • Refer to DTC Type Definitions for Condition for Clearing the DTC - Type D. Diagnostic Aids • If an intermittent condition is suspected, refer to Intermittent Conditions in this section. Notice: • This DTC will set if the cruise resume/ accel. switch continues being applied for longer than 120 Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Circuit/ System Testing DTC P0567 Step Action Value(s) Yes No 1 Did you perform the Diagnostic System Check - — Go to Step 2 Go to Diagnostic System Check - 2 1. Install a scan tool. 2. Turn ON the ignition, with the engine OFF. 3. Observe the Cruise Resume Switch Does the scan tool indicate ON when the switch is — Go to Diagnostic Aids Go to Step 3 3 1. Turn OFF the ignition. 2. Disconnect the combination switch harness 3. Turn ON the ignition, with the engine OFF. Does the Cruise Resume Switch parameter — Go to Step 5 Go to Step 4 4 1. Test the signal circuit between the ECM (pin 2. Repair the circuit(s) as necessary. Did you find and correct the condition? — Go to Step 7 Go to Step 6 5 Repair or replace the combination switch. Did you complete the repair or replacement? — Go to Step 7 — |