|
|
6-20 In case of emergency JVE0430X 6. Open the trunk. , then remove the trunk trim. 8. Remove the vent caps, if so equipped, on the battery. 9. Connect the jumper cables in the se- quence as illustrated ( , , , ). CAUTION . Always connect positive + to posi- tive + and negative 7 to body ground, NOT to the battery’s nega- 7. . Be sure that the jumper cables do not touch moving parts in the engine . Be sure that the jumper cable’s clamps do not contact any other 10. Start the engine of the booster vehicle and let it run for a few minutes. 11. Depress the accelerator pedal of the booster vehicle at about 2,000 rpm. 12. Start the engine of the jumped vehicle in the normal manner. CAUTION Never keep the starter motor engaged 13. After the engine is started, carefully disconnect the jumper cables in the , , ). 14. Replace the vent caps, if removed. NOTE: . If the engine cannot be started after the procedure above, both the main and the . If the engine cannot be started, even when the main and the auxiliary bat- |