|
|
CCS ACTION TEST CCS-79 < BASIC INSPECTION > [ICC] C D E F G H I J K L M B N P A • Cancel the control automatically when the vehicle speed is less than approximately 24 km/h (15 MPH) and when the system does not detect any vehicle ahead. >> GO TO 7. 7. SET CHECKING (2) 1. Stop the vehicle. 2. Drive the vehicle at less than approximately 32 km/h (20 MPH). 3. Push down the SET/COAST switch when the system detects a vehicle ahead. 4. Check that the vehicle-to-vehicle distance control mode is performed so that the vehicle maintains a NOTE: MPH) and when a vehicle ahead is not detected. • Cancel the control automatically when the vehicle speed is 24 km/h (15 MPH) or less during the control and when the system does not detect any vehicle ahead. • The set vehicle speed indicator in the ICC system display on the information display is set to 32 km/h (20 MPH). >> GO TO 8. 8. CHECK FOR INCREASE OF CRUISING SPEED (2) 1. Set the vehicle-to-vehicle distance control mode when the vehicle speed is less than approximately 32 2. Check that the set speed increases by 1 km/h (1 MPH) as RESUME/ACCELERATE switch is pushed up. NOTE: CAUTION: Never set the cruise speed exceeding the posted speed limit. >> GO TO 9. 9. CHECK FOR DECREASE OF CRUISING SPEED INSPECTION (2) 1. Set the vehicle-to-vehicle distance control mode when the vehicle speed is less than approximately 32 2. Set the set vehicle speed to the desired vehicle speed according to “check for increase of cruising speed”. 3. Check that the set speed decreases by 1 km/h (1 MPH) as SET/COAST switch is pushed down. NOTE: tem. The system will cancel once it judges a standstill with a warning chime. CAUTION: The creep occurs because the stop status is not maintained. >> GO TO 10. 10. CHECK FOR CANCELLATION OF VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE Check that the vehicle-to-vehicle distance control mode is canceled when performing the following operations. driven. • When the selector lever is in the “N” position after vehicle-to-vehicle distance control mode is set and the vehicle is driven. • When the MAIN switch is turned OFF after vehicle-to-vehicle distance control mode is set and the vehicle is driven. • When the CANCEL switch is pressed after vehicle-to-vehicle distance control mode is set and the vehicle is driven. >> GO TO 11. |