|
|
EM-136 < UNIT DISASSEMBLY AND ASSEMBLY > [VQ35HR] HOW TO SELECT PISTON AND BEARING HOW TO SELECT PISTON AND BEARING Description INFOID:0000000005245179 *: For the service parts, the grade for fitting cannot be selected between piston pin and connecting rod. (Only “0” grade is available.) The • The identification grade stamped on each part is the grade for the dimension measured in new condition. This grade cannot apply to reused parts. • For reused or repaired parts, measure the dimension accurately. Determine the grade by comparing the measurement with the values of each selection table. • For details of the measurement method of each part, the reuse standards and the selection method of the selective fitting parts, refer to the text. Piston INFOID:0000000005245180 WHEN NEW CYLINDER BLOCK IS USED Check the cylinder bore grade (“1”, “2” or “3”) on rear side of cylinder NOTE: WHEN NEW CYLINDER BLOCK IS REUSED 1. Measure the cylinder bore inner diameter. Refer to Selection points Selection parts Selection items Selection methods Between cylinder block and Main bearing Main bearing grade Determined by match of cylin- Between crankshaft and con- Connecting rod bearing Connecting rod bearing grade Combining service grades for Between cylinder block and pis- Piston and piston pin assembly Piston grade Piston grade = cylinder bore Between piston and connecting — — — A : Bearing housing grade No. 1 B : Bearing housing grade No. 2 C : Bearing housing grade No. 3 D : Bearing housing grade No. 4 E : Cylinder bore grade No. 1 F : Cylinder bore grade No. 2 G : Cylinder bore grade No. 3 H : Cylinder bore grade No. 4 I : Cylinder bore grade No. 5 J : Cylinder bore grade No. 6 K : Identification : Engine front JPBIA0268ZZ |