|
|
P0441 EVAP CONTROL SYSTEM EC-889 < DTC/CIRCUIT DIAGNOSIS > [VK50VE] C D E F G H I J K L M A EC N P O 2. PERFORM DTC CONFIRMATION PROCEDURE-I With CONSULT-III TESTING CONDITION: ° C (41 ° F) or more. 1. Start engine and warm it up to normal operating temperature. 2. Turn ignition switch OFF and wait at least 10 seconds. 3. Turn ignition switch ON. 4. Turn ignition switch OFF and wait at least 10 seconds. 5. Start engine and let it idle for at least 70 seconds. 6. Select “PURG FLOW P0441” of “EVAPORATIVE SYSTEM” in “DTC WORK SUPPORT” mode with CON- 7. Touch “START”. Is “COMPLETED” displayed on CONSULT-III screen? YES >> GO TO 4. NO >> GO TO 3. 3. PERFORM DTC CONFIRMATION PROCEDURE-II When the following conditions are met, “TESTING” will be displayed on the CONSULT-III screen. Maintain the CAUTION: Always drive vehicle at a safe speed. YES >> GO TO 4. NO >> Perform DTC CONFIRMATION PROCEDURE again. GO TO 2. 4. PERFORM DTC CONFIRMATION PROCEDURE-III Touch “SELF-DIAG RESULTS”. OK >> INSPECTION END NG >> Go to 5. PERFORM COMPONENT FUNCTION CHECK With GST Perform component function check. Refer to EC-889, "Component Function Check" . NOTE: Is the inspection result normal? YES >> INSPECTION END NO >> Go to Component Function Check INFOID:0000000005237363 1. PERFORM COMPONENT FUNCTION CHECK With GST 1. Lift up drive wheels. 2. Start engine (VDC switch OFF) and warm it up to normal operating temperature. Selector lever Suitable position VHCL SPEED SE 32 - 120 km/h (20 - 75 MPH) ENG SPEED 500 - 3,000 rpm B/FUEL SCHDL 1.3 - 9.0 msec COOLAN TEMP/S More than 0 ° C (32 ° F) |