|
|
REAR DOOR DLK-255 < REMOVAL AND INSTALLATION > C D E F G H I J L M A B DLK N O P • After installation, perform the fitting adjustment. Refer to DLK-255, "DOOR ASSEMBLY : Adjust- • After installation, apply touch-up paint (the body color) onto the head of door hinge mounting bolts and nuts. DOOR ASSEMBLY : Adjustment INFOID:0000000005239740 Check the clearance and surface height between rear door and each part by seeing and touching. Unit: mm (in) 1. Remove center pillar lower garnish. Refer to INT-17, "Removal and Installation" . 2. Loosen door hinge mounting nuts on door side. 3. Adjust the surface height of rear door according to the fitting standard dimension. 4. Temporarily tighten door hinge mounting nuts on door side. 5. Loosen door hinge mounting nuts and bolts on body side. 6. Raise rear door at rear end to adjust clearance of the rear door according to the fitting standard dimen- 7. After adjustment, tighten bolts and nuts to the specified torque. 8. Install center pillar lower garnish. Refer to INT-17, "Removal and Installation" CAUTION: • Apply anticorrosive agent onto the mounting surface. and nuts. DOOR STRIKER ADJUSTMENT Adjust door striker so that it becomes parallel with door lock insertion direction. DOOR STRIKER Portion Clearance Surface height Front door – Rear door B – B 3.0 – 5.0 (0.118 – 0.197) − 1.0 – 1.0 ( − 0.039 – 0.039) Rear door – Body side outer C – C 3.0 – 5.0 (0.118 – 0.197) − 1.0 – 1.0 ( − 0.039 – 0.039) |