|
|
WATER OUTLET AND WATER PIPING CO-25 < REMOVAL AND INSTALLATION > [VQ35HR] C D E F G H I J K L M A CO N P O • Never spill engine coolant on drive belt. 3. Remove engine cover. Refer to . 4. Remove air duct and air cleaner case assembly. Refer to . 5. Remove intake manifold collector. Refer to 6. Remove intake manifold. Refer to 7. Remove reservoir tank. Refer to . 8. Remove oil level gauge and guide. Refer to . 9. Remove radiator hose (upper) and heater hose. 10. Remove water outlet (front) and water outlet pipe. 12. Separate engine harness removing their bracket from water outlet (rear). 13. Remove engine coolant temperature sensor if necessary. CAUTION: Be careful not to damage engine coolant temperature sensor. 14. Remove water pipe, heater pipe, water bypass pipe, and water outlet (rear). INSTALLATION Note the following, and install in the reverse order of removal. CAUTION: Never allow water outlet (rear) to nip O-rings when installing water outlet pipe and water bypass pipe. Inspection INFOID:0000000005246375 INSPECTION AFTER INSTALLATION • Check that the reservoir tank cap is tightened. radiator cap tester (commercial service tool). Refer to . • Start and warm up the engine. Visually check that there is no leakage of engine coolant. |