|
|
PARKING BRAKE SWITCH BRC-99 < DTC/CIRCUIT DIAGNOSIS > [VDC/TCS/ABS] C D E G H I J K L M A B BRC N O P PARKING BRAKE SWITCH Component Function Check INFOID:0000000005234621 1. CHECK PARKING BRAKE SWITCH OPERATION Operate the parking brake pedal. Then check that the brake warning lamp in the combination meter turns ON/ Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to diagnosis procedure. Refer to . Diagnosis Procedure INFOID:0000000005234622 1. CHECK PARKING BRAKE SWITCH Check parking brake switch. Refer to BRC-99, "Component Inspection" Is the inspection result normal? YES >> GO TO 2. NO >> Replace parking brake switch. Refer to . 2. CHECK COMBINATION METER Check if the indication and operation of combination meter are normal. Refer to . Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace combination meter. 3. CHECK DATA MONITOR Select “ABS”, “DATA MONITOR” and “PARK BRAKE SW” in order with CONSULT-III, and perform the parking Is the inspection result normal? YES >> INSPECTION END NO >> Check unified meter and A/C amp. Refer to MWI-45, "CONSULT-III Function (METER/M&A)" Component Inspection INFOID:0000000005234623 1. CHECK PARKING BRAKE SWITCH 1. Turn the ignition switch OFF. 2. Disconnect parking brake switch harness connector. 3. Check the continuity between parking brake switch harness connector and ground. Condition Brake warning lamp illumination status When the parking brake pedal is operation ON When the parking brake pedal is not oper- OFF Condition PARK BRAKE SW (DATA MONITOR) Parking brake switch is active ON Parking brake switch is inactive OFF Parking brake switch — Condition Continuity Terminal 1 Ground When the parking brake switch is operated. Existed When the parking brake switch is not operated. Not existed |