|
|
Content .. 1872 1873 1874 1875 ..
SHIFT POSITION INDICATOR CIRCUIT TM-303 < DTC/CIRCUIT DIAGNOSIS > [7AT: RE7R01B (VK50VE)] C E F G H I J K L M A B TM N O P SHIFT POSITION INDICATOR CIRCUIT Description INFOID:0000000005250317 TCM transmit the switch signals to unified meter and A/C amp. by CAN communication line. Then manual Component Function Check INFOID:0000000005250318 1. CHECK A/T INDICATOR 1. Start the engine. 2. Check the actual selector lever position (“P”, “R”, “N” and “D”) and the indication of the shift position indi- 3. Drive vehicle in the manual mode, and then check that the actual gear position and the indication of the − side)” side (1GR ⇔ 7GR). Is the inspection result normal? YES >> INSPECTION END NO >> Go to Diagnosis Procedure INFOID:0000000005250319 1. CHECK INPUT SIGNALS With CONSULT-III 1. Start the engine. 2. Select “SLCT LVR POSI” in “Data Monitor” in “TRANSMISSION”. 3. Check the actual selector lever position (“P”, “R”, “N” and “D”) and the indication of the “SLCT LVR POSI” . 4. Drive vehicle in the manual mode, and then check that the actual gear position and the indication of the − side)” side (1GR ⇔ 7GR). Refer to . Is the inspection result normal? YES >> INSPECTION END NO-1 [The actual gear position does not change, or shifting into the manual mode is not possible (no gear manual TM-294, "Component Inspection (Manual Mode Switch)" • Check A/T main system (Fail-safe function actuated). . NO-2 (The actual gear position changes, but the shift position indicator is not indicated.)>>•Perform “Self Diagnostic Results” mode for “TRANSMISSION”. Refer to NO-3 (The actual gear position and the indication on the shift position indicator do not coincide.)>>•Perform “Self Diagnostic Results” mode for “TRANSMISSION”. Refer to . NO-4 (Only a specific position or positions is/are not indicated on the shift position indicator.)>>•Check the unified meter and A/C amp. Refer to . |