Hummer H2. Manual - part 511

 

  Index      Hummer     Hummer H2 - service repair manual 2004 year

 

Search            

 

 

 

 

 

 

 

  

 

Content   ..  509  510  511  512   ..

 

 

Hummer H2. Manual - part 511

 

 

POWER DOOR LOCKS INOPERATIVE (REAR DOOR(S)) 

Power Door Locks Inoperative (Rear Door(s)) 

Did you find and correct the condition?

Go to Step 13

Go to Step 11

10

Inspect for poor connections at the harness 
connector of the door lock actuator. Refer to Testing 
for Intermittent Conditions and Poor 
Connections and Connector Repairs in Wiring 
Systems. 
Did you find and correct the condition?

Go to Step 13

Go to Step 12

11

Replace the appropriate door module. Refer to 
Switch Replacement - Door Lock and Side 
Window - Driver or Switch Replacement - Door 
Lock and Side Window - Passenger .Did you 
complete the repair?

IMPORTANT:

Perform the set up procedure for the door 
module. Refer to Service Programming System 
(SPS) in Programming.

Go to Step 13

-

12

Replace the appropriate door lock actuator. Refer to 
Latch Replacement - Front Door . 
Did you complete the repair?

Go to Step 13

-

13

Operate the system in order to verify the repair. 
Did you correct the condition?

System OK

Go to Step 2

Step

Action

Yes

No

Schematic Reference: Door Lock/Indicator Schematics 
Connector End View Reference: Power Door Systems Connector End Views

1

Did you perform the Door Systems Diagnostic 
System Check?

Go to Step 2

Go to Diagnostic 

System Check - 

Door Systems

2

Activate the front door lock switches to the lock 
and unlock positions. 
Do both rear passenger doors lock and unlock?

Go to Testing for 

Intermittent Conditions 

and Poor Connections in 

Wiring Systems

Go to Step 3

3

Is there only one door lock actuator that is 
inoperative?

Go to Power Door Locks 

Inoperative - One Door 

or Switch

Go to Step 4

4

Are the rear door lock actuators inoperative for 
both lock and unlock?

Go to Step 6

Go to Step 5

5

Do the rear door lock actuators lock?

Go to Step 17

Go to Step 12

6

Is the LOCKS fuse open?

Go to Step 24

Go to Step 7

1. Remove the door unlock relay.  

 

2004 Hummer H2 

2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2

  

7

2. Connect a test lamp to a good ground.  

3. Probe the door unlock relay coil battery 

supply voltage circuit.  

Does the test lamp illuminate?

Go to Step 8

Go to Step 27

8

1. Connect a test lamp to battery positive 

voltage.  

2. Probe the door actuator unlock control circuit 

cavity in the fuse block.  

Does the test lamp illuminate?

Go to Step 10

Go to Step 9

9

1. Install the rear door unlock relay.  

2. Remove the rear door lock relay.  

3. Connect a test lamp to battery positive 

voltage.  

4. Probe the door lock actuator lock control 

circuit cavity in the fuse block.  

Does the test lamp illuminate?

Go to Step 11

Go to Step 27

10

1. Connect a test lamp to battery positive 

voltage.  

2. Probe the rear door unlock relay control 

circuit.  

Does the test lamp illuminate?

Go to Step 22

Go to Step 26

11

1. Connect a test lamp to battery positive 

voltage.  

2. Probe the rear door lock relay control circuit. 

Does the test lamp illuminate?

Go to Step 23

Go to Step 25

12

1. Remove the rear door lock relay.  

2. Connect a test lamp to a good ground.  

3. Probe the battery positive voltage circuit 

(high current) cavity in the fuse block.  

Does the test lamp illuminate?

Go to Step 13

Go to Step 27

13

With the test lamp connected to a good ground, 
probe the lock relay control circuit cavity in the 
fuse block. 
Does the test lamp illuminate?

Go to Step 22

Go to Step 14

1. Connect a test lamp to battery positive 

 

2004 Hummer H2 

2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2

  

14

voltage.  

2. Probe the lock relay control circuit cavity in 

the rear fuse block.  

3. Activate a door lock switch to the lock 

position.  

Does the test lamp illuminate?

Go to Step 15

Go to Step 22

15

With the test lamp connected to battery positive 
voltage, probe the door lock actuator lock control 
circuit cavity in the fuse block. 
Does the test lamp illuminate?

Go to Step 25

Go to Step 16

16

1. Remove the rear door unlock relay.  

2. With the test lamp connected to battery 

positive voltage, probe the unlock relay 
ground circuit cavity in the fuse block.  

Does the test lamp illuminate?

Go to Step 26

Go to Step 27

17

1. Remove the rear door unlock relay.  

2. Connect a test lamp to a good ground.  

3. Probe the battery positive voltage circuit 

(high current) cavity in the fuse block.  

Does the test lamp illuminate?

Go to Step 18

Go to Step 27

18

With the test lamp connected to a good ground, 
probe the unlock relay control circuit cavity in the 
fuse block. 
Does the test lamp illuminate?

Go to Step 23

Go to Step 19

19

1. Connect a test lamp to battery positive 

voltage.  

2. Probe the unlock relay control circuit cavity 

in the fuse block.  

3. Activate a door lock switch to the unlock 

position.  

Does the test lamp illuminate?

Go to Step 20

Go to Step 23

20

With the test lamp connected to battery positive 
voltage, probe the door lock actuator unlock 
control circuit cavity in the rear fuse block. 
Does the test lamp illuminate?

Go to Step 25

Go to Step 21

21

1. Remove the rear door lock relay.  

2. With the test lamp connected to battery 

positive voltage, probe the lock relay ground 

 

2004 Hummer H2 

2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2

  

circuit cavity in the rear fuse block.  

Does the test lamp illuminate?

Go to Step 25

Go to Step 27

22

Test for an open short to ground or short to battery 
in the door lock relay lock control circuit. 
Refer to Circuit Testing and Wiring Repairs in 
Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 28

23

Test for an open short to ground or short to battery 
in the door unlock relay lock control circuit. 
Refer to Circuit Testing and Wiring Repairs in 
Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 28

24

Test for a short to ground in the door lock actuator 
lock and unlock control circuits. 
Refer to Circuit Testing and Wiring Repairs in 
Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 27

25

Inspect for poor connections at the rear door lock 
relay. Refer to Testing for Intermittent 
Conditions and Poor Connections and 
Connector Repairs in Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 29

26

Inspect for poor connections at the rear door unlock 
relay. Refer to Testing for Intermittent 
Conditions and Poor Connections and 
Connector Repairs in Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 30

27

Inspect for poor connections at the fuse block. 
Refer to Testing for Intermittent Conditions and 
Poor Connections and Connector Repairs in 
Wiring Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 31

28

Inspect for poor connections at the harness 
connector of the body control module. Refer to 
Testing for Intermittent Conditions and Poor 
Connections and Connector Repairs in Wiring 
Systems. 
Did you find and correct the condition?

Go to Step 33

Go to Step 32

29

Replace the rear door lock relay. 
Did you complete the repair?

Go to Step 33

-

30

Replace the rear door unlock relay. 
Did you complete the repair?

Go to Step 33

-

31

Replace the rear fuse block. 
Did you complete the repair?

Go to Step 33

-

 

2004 Hummer H2 

2004 ACCESSORIES & EQUIPMENT Doors - Hummer H2

  

 

 

 

 

 

 

 

Content   ..  509  510  511  512   ..