|
|
The numbers below refer to the step numbers on the diagnostic table. 1: Determines if the malfunction is present. 3: Tests for an open in the vehicle speed signal circuit between the instrument cluster and the navigation DTC B0004 DTC B2462 Circuit Description The global positioning system (GPS) antenna is connected to the navigation radio by a coaxial cable. Conditions for Running the DTC The radio must detect one of the following power modes: Step Action Yes No Schematic Reference:Navigation System Schematics 1 Did you perform the Diagnostic System Check - Go to Step 2 Go Diagnostic System Check - Navigation System 2 Verify the instrument cluster speedometer operation. Go to Step 3 Go to Diagnostic Starting Point - Instrument Panel, Gauges and Console in Instrument Panel, Gauges and Console 3 Test the vehicle speed signal circuit for an open Go to Step 6 Go to Step 4 4 Inspect for poor connections at the harness connector Go to Step 6 Go to Step 5 5 Replace the navigation radio. Refer to Radio Go to Step 6 - 6 1. Use the scan tool in order to clear the DTC. 2. Drive the vehicle at least 4 km (2.5 mi) with the GPS signal received. 3. Leave vehicle running and retrieve DTCs. Does the DTC reset? Go to Step 2 System OK
2004 Hummer H2 2004 ACCESSORIES & EQUIPMENT Navigation Systems - Hummer H2
|