DTC P0132 OR P0152
Circuit Description
Heated oxygen sensors (HO2S) are used for fuel control and post catalyst monitoring. Each HO2S compares the
oxygen content of the surrounding air with the oxygen content in the exhaust stream. The HO2S must reach
operating temperature to provide an accurate voltage signal. Heating elements inside the HO2S minimize the
time required for the sensors to reach operating temperature. The powertrain control module (PCM) supplies the
HO2S with a reference, or bias, voltage of about 450 mV. When the engine is first started the PCM operates in
open loop, ignoring the HO2S voltage signal. Once the HO2S reaches operating temperature and closed loop is
achieved, the HO2S generates a voltage within a range of 0-1,000 mV that fluctuates above and below bias
voltage. High HO2S voltage indicates a rich exhaust stream; low HO2S voltage indicates a lean exhaust stream.
If the PCM detects an HO2S voltage that stays above a specified value, DTC P0132 sets for HO2S bank 1
sensor 1, or DTC P0152 sets for HO2S bank 2 sensor 1.
Conditions for Running the DTC
Rich Test Enable:
z
DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120,
P0200, P0220, P0300, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101,
P2108, P2135, U0107 are not set.
z
The Loop Status parameter is closed.
13
Replace the affected HO2S. Refer to Heated Oxygen
Sensor (HO2S) Replacement Bank 1 Sensor 1 or
Heated Oxygen Sensor (HO2S) Replacement Bank
2 Sensor 1 .
Did you complete the replacement?
-
Go to Step 15
-
14
Replace the PCM. Refer to Powertrain Control
Module (PCM) Replacement .
Did you complete the replacement?
-
Go to Step 15
-
15
1. Clear the DTCs with a scan tool.
2. Turn OFF the ignition for 30 seconds.
3. Start the engine.
4. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within the conditions that you observed
from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
-
Go to Step 2
Go to Step 16
16
Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
-
Go to
Diagnostic
Trouble Code
(DTC) List
System OK
2004 Hummer H2
2004 ENGINE PERFORMANCE Engine Controls Diagnosis (DTC P0068 To DTC P0141/P0161) - 4.8L, 5.3L, and 6.0L -
Hummer H2