|
|
S0X4A00A20336147201BAAT00 11-202 Idle Control System PCM Idle Learn Procedure procedure must be done. Do the idle learn procedure whenever you do any of • Disconnect the battery. NOTE: Clearing DTCs with the HDS does not require • Remove the No. 13 CLOCK BACK UP (7.5A) fuse from the passenger’s under-dash fuse/relay box. • Remove the BATTERY (120A) fuse from the under- hood fuse/relay box. • Remove the BACK UP, ACC (40A) fuse from the under-hood fuse/relay box. • Remove any of the wires from the under-hood fuse/ relay box. • Remove any of the wires from the driver’s/passenger’s under-dash fuse/relay box. • Disconnect any of the connectors from the under- hood fuse/relay box. • Disconnect any of the connectors from the driver’s/ passenger’s under-dash fuse/relay box. • Disconnect the connector between the engine wire harness and left engine compartment wire harness. • Disconnect the G2 terminal from the transmission housing. • Disconnect the G1 terminal from the body. manifold. 1. Make sure all electrical items (A/C, audio, rear window defogger, lights, etc.,) are off. 2. Start the engine, and hold it at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes 3. Let the engine idle for a minimum of 5 minutes with no load. NOTE: If the radiator fan cycles during this time, do 03/07/29 09:24:12 61S0X050_110_0202 For the PCM to learn the engine idle characteristics, this Procedure: |