217

Section 5 Rear Combination Lamp Replacement

I. REMOVAL

1. Remove rear trunk seal strip and interior trimming.

2. Remove the 3 mounting bolts (A, B, C as shown in the illustration).

3. Remove the rear combination lamp electrical connector.

4. Pull the rear combination lamp assembly backwards.

Seal  Strip

Interior Trimming

Buckle and Plug

A

B

C

Electrical 
Connecto

r

218

II. INSTALLATION

1. Install the rear combination lamp and then the 3 mounting bolts.

2. Install the electrical connector.

3. Install the rear trunk interior trim.

4. Install the seal strip.

III. REAR COMBINATION LAMP BULB REPLACEMENT

1. Remove the O-ring seal.

2. Turn the lamp-holder counter-clockwise. Pull out the lamp-holder.

3. Remove the bulb and replace the bulb.

Section 6 High Mounted Stop Lamp Replacement

z

Remove the High mounted stop lamp in direction 1 and 2. (as shown above in the illustration)

z

Disconnect the connector.

Partition

High Mounted 
Stop Lamp

219

Section 7 Interior Dome Lamp Replacement

1. Gently Pry the lamp shield off at the point a with a screwdriver.

2. Remove the 2 mounting bolts with a screwdriver (take care not to touch the bulb).

3. Pull the High mounted stop lamp assembly downwards.

4. Pull out the electrical connector.

Roof Panel Interior Trim

Lamp Body

Lamp Shield

a

Fixing Screw

220

Roof Panel Interior
Trim

Rear Reading Lamp
(original status)

Section 8 Rear Row Reading Lamp Replacement

1. Gently pry the rear row reading lamp off at the point a with a screwdriver (Position 1 as shown in the

illustration).

2. Pull out the rear reading lamp downwards with an angle (Position 2 as shown in the illustration)

3. Remove the electrical connector.

Section 9 License Plate Lamp Replacement

1. Remove the license plate lamp with a screwdriver.

2. Remove the electrical connector.