Wiper Switch Harness Connector IP19

FE11-5519c

(a)

Disconnect the rear wiper switch.

(b)

Turn on the rear washer switch.

(c)

Connect a multimeter between the rear wiper switch
terminals 11 and 17.
Resistance Standard Value: Less than 1 Ω

Is the resistance specified value?

No

Go to step 12

Yes

Step 11

Check the circuit between the rear wiper switch wiring harness connector terminal No.17 and the rear washer
pump connector terminal No.2.

Wiper Switch Harness Connector IP19

Rear Washer Motor Harness Connector CA25

FE11-5520c

(a)

Check the circuit between the rear wiper switch wiring
harness connector terminal No.17 and the rear washer pump
connector terminal No.2.

(b)

Repair the open circuit between the rear wiper switch wiring
harness connector terminal No.17 and the rear washer pump
connector terminal No.2.

Confirm whether the wipers are work properly.

Yes

System normal

No

Step 12

Replace the wiper switch.

(a)

Replace the wiper switch. Refer to 

11.6.8.8

 

Wiper and

Washer Switch Replacement

.

Confirm the repair completed.

Body Electric

Wipers / Washers System

11-249

Next

Step 13

System normal.

11-250

Wipers / Washers System

Body Electric

11.6.8 Removal and Installation
11.6.8.1 Wiper Blade Replacement

Removal Procedure

FE11-0408b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Lift the wiper arm.

FE11-0409b

3.

Move the retaining clip upward.

FE11-0410b

4.

Hold the wiper arm, move the wiper blade downward to
remove the wiper blade.

Note

If new parts are not immediately replaced, put down
the wiper arm gently to prevent the damage to the
windshield.

Body Electric

Wipers / Washers System

11-251

Installation Procedure:

FE11-0410b

1.

Install  the  wiper  blade,  until  the  wiper  blade  arm  is
tightened with the wipers.

FE11-0409b

2.

Move the wiper blade retaining clip, until the clip is back
to its original position.

3.

Lower the wiper arm gently.

4.

Connect the battery negative cable.

11.6.8.2 Wiper Arm Replacement

Removal Procedure

FE11-0411b

1.

Before removal place the wiper arm at its initial position.

11-252

Wipers / Washers System

Body Electric