7.3.2 Description and Operation
7.3.2.1 Description and Operation
Warning!
Refer to "SIR Warning" in "Warnings and Notices".
Note
Refer to "Steering Wheel in the Full Turn Position Notice"
in "Warnings and Notices".
Note
Disconnect the mechanical steering column assembly,
the upper intermediate shaft assembly, the lower
intermediate shaft assembly. The wheels should be kept
in the straight front direction, the mechanical steering
column assembly must be in the LOCK (locked) position.
After disconnecting the above components, do not move
the front tires and wheels, otherwise it will cause some
parts incorrect installation location, and lead to
mechanical steering column assembly airbag spiral off
the center, resulting in airbag spiral coil damage.
Note
Steering column can not only change the vehicle
direction, but also provide protection. To ensure the
steering column energy absorption, make sure use the
provided screws, bolts and nuts and tighten to the
required torque.
In the event of front end collision energy absorbing
column will crumple, reducing the chance of injury to the
driver.
Ignition switch includes a steering wheel lock, installed in the
mechanical steering column assembly. It is able to lock the
steering wheel to prevent theft. When the ignition key is
removed from the ignition switch, turn the steering wheel left
and right, the pin inside the ignition switch pops up to lock the
steering wheel. Release the locking handle, the steering wheel
can tilt up and down. Therefore, the driver can adjust the
steering wheel to a comfortable position. When driver leaves
the vehicle, if the key is still inside the ignition switch, the
reminder device inside the ignition key will beep to remind the
driver. Refer to the
11.10
Remote Anti-theft System
.
Note
When reassemble, apply a thin layer of lithium-based
grease at all friction points. In this way, mechanical
steering column assembly can removed and assembled
easily.
Steering System
Steering Wheel and Steering Column
7-39