FE07-0011b

3.

Disconnect the power steering outlet pipe from the fluid
reservoir.

FE07-0012b

4.

Remove the steering system pipe bracket bolt from the
subframe.

FE07-0013b

5.

Remove the power steering inlet/outlet pipe bracket bolts
from the power steering pump assembly.

Steering System

Hydraulic Power Steering System

7-23

FE07-0014b

6.

Lift and support the vehicle. Refer to 

1.3.1.1

 

Lifting and

Jacking the Vehicle

.

7.

Disconnect the high pressure fluid pipe and the return pipe
from the power steering gear assembly horizontal bar.

FE07-0015b

8.

Remove the pipe bracket bolt from the subframe.

9.

Remove the return pipe and the high pressure pipe from
the vehicle.

Installation Procedure:

FE07-0015b

1.

Connect the high pressure pipe from the power steering
pump assembly to the power steering gear.

2.

Connect  the  return  pipe  from  the  fluid  reservoir  to  the
power steering gear.

3.

Lift and support the vehicle.

4.

Install the fluid pipe to the subframe and tighten the bolts.

Torque: 10 Nm (Metric) 7.4 lb-ft (US English)

7-24

Hydraulic Power Steering System

Steering System

FE07-0014b

5.

Connect the high pressure pipe and the return pipe to the
power steering gear and tighten.

Torque: 28 Nm (Metric) 20.7 lb-ft (US English)

FE07-0013b

6.

Install the high pressure pipe bracket bolts to the power
steering pump assembly.

Torque: 10 Nm (Metric) 7.4 lb-ft (US English)

FE07-0012b

7.

Install the steering system pipe bracket to the right side
crossmember and tighten.

Torque: 10 Nm (Metric) 7.4 lb-ft (US English)

Steering System

Hydraulic Power Steering System

7-25

FE07-0011b

8.

Connect the steering system pipe to the fluid reservoir.

FE07-0010b

9.

Connect the fluid supply hose and high pressure pipe to
the power steering pump assembly.

Torque: 30 Nm (Metric) 22.2 lb-ft (US English)

10. Fill  the  power  steering  fluid  to  the  power  steering  fluid

reservoir.

11. Check the existence for pipe leakage. if there is leakage,

repeat the above steps to re-install the pipe, and bleed air
in the pipes.

7.2.8.7 Power Steering System Bleeding

1.

Shut down the engine. Turn the steering wheel from one
locking position to the other, repeat several times.

2.

Start the engine, let the engine run at idle, check the power
steering fluid level. If necessary, add fluid, so that the fluid
level is remained above "MIN".

3.

Turn the steering wheel back and forth, but do not fully
turn the steering wheel, bleed the system. To maintain the
fluid  level  above  "MIN",  bleed  the  system  to  obtain  the
proper power steering performance.

4.

Return the steering wheel to the straight position, let the
engine continue to run at idle for 2-3 min.

5.

Road test the vehicle, confirm whether the power steering
is  functioning  correctly  and  whether  there  is  abnormal
sound.

7-26

Hydraulic Power Steering System

Steering System