FE02-0012b

7.

Remove the cylinder head cover.

FE02-0013b

8.

Remove the cylinder head gasket from the cylinder head
cover.

Engine

Engine Mechanical System JL4G18-D

2-331

Installation Procedure:

FE02-0014b

1.

Install the cylinder head cover gasket.

FE02-0015b

2.

Apply sealant evenly in the cylinder head gasket.

3.

Install the cylinder head cover.

2-332

Engine Mechanical System JL4G18-D

Engine

FE02-0011b

4.

Tighten the cylinder head cover bolts.

Note

When tightening, tighten a single bolt several times,
in accordance with the specified torque.
Short Bolts:
Torque: 9 Nm (Metric) 6.7 lb-ft (US English)

Long Bolts, Nuts, Special Bolts:
Torque: 11 Nm (Metric) 8.2 lb-ft (US English)

FE02-0017b

5.

Install the crankcase ventilation vacuum tube.

FE02-0018b

6.

Install the crankcase ventilation tube.

7.

Install ignition coil and ignition wire.

8.

Install the engine plastic shield.

9.

Connect the battery negative cable.

2.6.8.3 Drive Belt Replacement

Removal Procedure:

Warning!

Refer to "Battery Disconnection Warning" in "Warnings
and Notices".

Engine

Engine Mechanical System JL4G18-D

2-333

FE01-0019b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Rotate  the  drive  belt  tensioner  anti-clockwise  with  a
wrench to remove the drive belt.

Note

In the removal process, prevent the wrench slipping
causing injury to the operator.

Installation Procedure:

FE01-0020b

1.

Wrap the drive belt as shown.

FE01-0021b

2.

Rotate the drive belt tensioner clockwise with a wrench to
install the drive belt.

2-334

Engine Mechanical System JL4G18-D

Engine