FE02-0034b

6.

Connect the fuel pipe.

Note

The fuel pipe must be inserted into the fuel rail after
the second boss and then tightened with the clips.

FE02-0035b

7.

Connect the fuel injector wiring harness connector.

FE02-0036b

8.

Restore the self-locking device.

Engine

Control System JL4G18-D

2-211

FE02-0037b

9.

Install the crankcase ventilation tube.

10. Connect the battery negative cable.

Note

Start  the  engine.  Check  fuel  and  fuel  injectors  for
fuel leaks and vacuum leaks.

11. Install the engine hood.

2.2.8.3 Throttle Position Sensor Replacement

Removal Procedure:

Note

Refer  to  "Battery  Disconnection  Warning"  in  the
"Warnings and Important Notices".

FE02-0038b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Remove  the  throttle  body  assembly.  Refer  to

2.6.8.5

 

Throttle Body Assembly Replacement

.

3.

Remove the throttle position sensor retaining bolts.

2-212

Control System JL4G18-D

Engine

Installation Procedure:

FE02-0039b

1.

Install  and  tighten  the  throttle  position  sensor  retaining
bolts.

Note

During  the  installation  procedure  align  the  throttle
shaft groove with the sensor boss.

2.

Install the throttle body assembly.

3.

Connect the battery negative cable.

2.2.8.4 VVT Solenoid Valve Replacement and
Filter Cleaning

Removal Procedure:

Warning!

Refer  to  "Battery  Disconnection  Warning"  in  the
"Warnings and Important Notices".

FE02-0040b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Remove the hood. Refer to 

2.6.8.1

 

Plastic Engine Shield

Replacement

.

3.

Disconnect VVT solenoid valve wiring harness connector.

Engine

Control System JL4G18-D

2-213

FE02-0041b

4.

Remove VVT solenoid valve retaining bolts and remove
the VVT solenoid valve.

Installation Procedure:

Note

After replacing the VVT solenoid valve, you must carry
out the "Clean Solenoid Valve Filter" procedure, other it
cause electromagnetic valve damage.

FE02-0042b

1.

Make sure the new VVT solenoid valve seals are intact.
Apply a small amount of engine oil on the seal.

FE02-0043b

2.

Install  the  VVT  solenoid  valve  and  fasten  the  retaining
bolts.

Torque: 8 Nm (Metric) 6 lb-ft (US English)

2-214

Control System JL4G18-D

Engine