Ford Windstar (2003 year). Manual - part 30

 

  Index      Ford     Ford Windstar - service manual 2003 year in english

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  28  29  30  31   ..

 

 

Ford Windstar (2003 year). Manual - part 30

 

 

of providing a tether anchorage. For more information on top tether
straps, refer to Attaching safety seats with tether straps.

Carefully follow all of the manufacturer’s instructions included
with the safety seat you put in your vehicle. If you do not install

and use the safety seat properly, the child may be injured in a sudden
stop or collision.

Installing child safety seats in cinch tongue combination lap and
shoulder belt seating positions

The belt webbing below the tongue is the lap portion of the combination
lap/shoulder belt, and the belt webbing above the tongue is the shoulder
belt portion of the combination lap/shoulder belt.

1. Position the child safety seat in a
seat with a combination lap and
shoulder belt.

Air bags can kill or injure a child in a child seat. If you must use
a forward-facing child seat in the front seat, move seat all the

way back.

Rear facing child seats should NEVER be placed in front of an
active air bag.

Seating and Safety Restraints

122

2. Slide the tongue up the webbing.

3. While holding both shoulder and
lap portions next to the tongue,
route the tongue and webbing
through the child seat according to
the child seat manufacturer’s
instructions. Be sure that the belt
webbing is not twisted.

4. Insert the belt tongue into the
proper buckle for that seating
positions until you hear a snap and
feel it latch. Make sure the tongue is
securely latched to the buckle by
pulling on the tongue.

Seating and Safety Restraints

123

5. While pushing down with your
knee on the child seat pull up on
the shoulder belt portion to tighten
the lap belt portion of the
combination lap and shoulder belt.

6. Allow the safety belt to retract and remove any slack in the belt to
securely tighten the child safety seat in the vehicle.

7. Before placing the child into the
child seat, forcibly pull the child
seat forward and back to make sure
that the seat is held securely in
place. To check this, grab the seat
at the belt path and attempt to
move it side to side and forward and
back. There should be no more than
one inch of movement for proper
installation.

8. Check from time to time to be sure that there is no slack in the
lap/shoulder belt. The shoulder belt must be snug to keep the lap belt
tight during a collision.

Installing child safety seats in the lap belt seating positions

1. Lengthen the lap belt. To lengthen the belt, hold the tongue so that its
bottom is perpendicular to the direction of webbing while sliding the
tongue up the webbing.

2. Place the child safety seat in the center seating position.

3. Route the tongue and webbing through the child seat according to the
child seat manufacturer’s instructions.

4. Insert the belt tongue into the proper buckle for the center seating
position until you hear a snap and feel it latch. Make sure the tongue is
securely fastened to the buckle by pulling on tongue.

5. Push down on the child seat while pulling on the loose end of the lap
belt webbing to tighten the belt.

Seating and Safety Restraints

124

6. Before placing the child into the child seat, forcibly tilt the child seat
from side to side and in forward direction to make sure that the seat is
securely held in place. To check this, grab the seat at the belt path and
attempt to move it side to side and forward and back. There should be
no more than one inch of movement for proper installation.

Attaching child safety seats with tether straps

Most new forward-facing child safety seats include a tether strap which
goes over the back of the seat and hooks to an anchoring point. Tether
straps are available as an accessory for many older safety seats. Contact
the manufacturer of your child seat for information about ordering a
tether strap.

Children should be placed in the rear in an appropriate child
safety seat that is properly secured to the vehicle.

The tether anchors in your vehicle
are in the positions shown:

The tether can be attached directly to the rear of all passenger seating
except the front passenger seat equipped with power adjustment. The
front passenger seat with manual adjustment does have a tether anchor.

Seating and Safety Restraints

125

 

 

 

 

 

 

 

Content   ..  28  29  30  31   ..