Ford Mustang (2018 year). Manual - part 16

VOICE CONTROL

 (If Equipped)

Type One

E248479

Type Two

E248439

Make or answer a call.

A

Voice recognition.

B

Media.

C

End call.

D

See your SYNC information.

CRUISE CONTROL

Type One

E174594

See Using Cruise Control (page 163).

Type Two

E177068

See Using Adaptive Cruise Control
(page 164).

INFORMATION DISPLAY
CONTROL

E248474

E248475

Quick Action Menus

E248531

See Information Displays (page 88).

HEATED STEERING WHEEL

 (If

Equipped)

See your SYNC information.

WINDSHIELD WIPERS

Note: Fully defrost the windshield before
you switch the windshield wipers on.

Note: Make sure you switch the windshield
wipers off before entering a car wash.

Note:  If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades.  If that does not resolve the
issue, install new wiper blades.

Note:  Do not operate the wipers on a dry
windshield.  This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out.  Always use the
windshield washers before wiping a dry
windshield.

E173728

Single wipe.

A

Intermittent wipe.

B

Normal wipe.

C

High speed wipe.

D

Intermittent Wipe

E173729

Shortest wipe interval.

A

Intermittent wipe.

B

Longest wipe interval.

C

Use the rotary control to adjust the
intermittent wipe interval.

Speed Dependent Wipers

When your vehicle speed increases, the
interval between wipes decreases.

AUTOWIPERS

 (If Equipped)

Note: Fully defrost the windshield before
you switch the windshield wipers on.

Note: Make sure you switch the windshield
wipers off before entering a car wash.

Note:  If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades.  If that does not resolve the
issue, install new wiper blades.

Note: If you switch autolamps and
autowipers on, the headlamps turn on when
the windshield wipers continuously operate.

Wet or winter driving conditions with ice,
snow or salty road mist can cause
inconsistent and unexpected wiping or
smearing.

The feature uses a rain sensor that is in the
area around the interior mirror. The rain
sensor monitors the amount of moisture
on the windshield and turns on the wipers.
It adjusts the wiper speed by the amount
of moisture that the sensor detects on the
windshield. You can switch this feature on
and off in the information display.  See
Information Displays (page 88).

E173730

Highest sensitivity.

A

On.

B

Lowest sensitivity.

C

Use the rotary control to adjust the
sensitivity of the autowipers.  When you
select low sensitivity, the wipers operate
when the sensor detects a large amount
of water on the windshield.  When you
select high sensitivity, the wipers operate
when the sensor detects a small amount
of water on the windshield.

Keep the outside of the windshield clean.
The rain sensor is very sensitive and the
wipers may operate if dirt, mist or insects
hit the windshield.

In these conditions, you can do the
following:
•

Lower the sensitivity of the autowipers
to reduce the amount of smearing on
the windshield.

•

Switch to normal or high-speed wipe.

•

Switch autowipers off.

WINDSHIELD WASHERS

Note: Do not operate the washers when
the washer reservoir is empty. This may
cause the washer pump to overheat.

E173731

To operate the washers and spray the
windshield, pull the lever toward you.