Ford Expedition (2018 year). Manual - part 26

It also illuminates momentarily when you
switch the ignition on to confirm the lamp
is functional. If it does not illuminate when
you switch the ignition on, or begins to
flash at any time, have the system checked
by your authorized dealer.

Oil Pressure Warning Lamp

It illuminates when you switch
the ignition on.

If it illuminates when the engine

is running this indicates a malfunction.
Stop your vehicle as soon as it is safe to
do so and switch the engine off.  Check the
engine oil level.  If the oil level is sufficient,
this indicates a system malfunction.  Have
your vehicle checked as soon as possible.

See Engine Oil Check (page 317).

Powertrain Malfunction/Reduced
Power/Electronic Throttle Control

Illuminates when a powertrain
or a 4WD fault has been
detected.  Have your vehicle

checked as soon as possible.

Service Engine Soon

If it illuminates when the engine
is running this indicates a
malfunction.  The On Board

Diagnostics system has detected a
malfunction of the vehicle emission control
system.

If it flashes, engine misfire may be
occurring.  Increased exhaust gas
temperatures could damage the catalytic
converter or other vehicle components.
Drive in a moderate fashion (avoid heavy
acceleration and deceleration) and have
your vehicle immediately serviced.

It illuminates when you switch the ignition
on prior to engine start to check the bulb
and to indicate whether your vehicle is
ready for Inspection and Maintenance
(I/M) testing.

Normally, it illuminates until the engine is
cranked and automatically turns off if no
malfunctions are present. However, if after
15 seconds it flashes eight times, this
indicates that your vehicle is not ready for
Inspection and Maintenance (I/M) testing.

See Catalytic Converter (page 184).

Stability Control and Traction
Control Indicator

E138639

Flashes during operation.

If it does not illuminate when you
switch the ignition on, or remains

on when the engine is running, this
indicates a malfunction.  Have your vehicle
checked as soon as possible.

Note:

The system automatically turns off

if there is a malfunction.

See Using Stability Control (page 209).

Stability Control and Traction
Control Off Warning Lamp

E130458

It illuminates when you switch
the system off.

Tow Haul Indicator

E246592

Illuminates when the tow/haul
feature has been activated. If the
light flashes steadily, have the

system serviced immediately, damage to
the transmission could occur.

AUDIBLE WARNINGS AND
INDICATORS

Key in Ignition Warning Chime

Sounds when you leave the key in the
ignition and the driver door open.

Headlamps On Warning Chime

Sounds when the headlamps or parking
lamps are on, the ignition is off (the key is
not in the ignition) and the driver door is
open.

Parking Brake On Warning Chime

Sounds when you have left the parking
brake on and drive your vehicle. If the
warning chime remains on after you have
released the parking brake, have the
system checked by an authorized dealer
immediately.

Direction Indicator Chime

Sounds when you leave the direction
indicator on after signaling a turn and
driving the vehicle more than 1.5 miles (2.4
km).

GENERAL INFORMATION

WARNING

Driving while distracted can result in
loss of vehicle control, crash and
injury. We strongly recommend that

you use extreme caution when using any
device that may take your focus off the
road. Your primary responsibility is the safe
operation of your vehicle. We recommend
against the use of any hand-held device
while driving and encourage the use of
voice-operated systems when possible.
Make sure you are aware of all applicable
local laws that may affect the use of
electronic devices while driving.

Various systems on your vehicle can be
controlled using the information display
controls on the steering wheel.
Corresponding information is displayed in
the information display.

Note:

Some options may appear slightly

different or not at all if the items are
optional.

Note:

Trailer options are not available if

your vehicle speed is greater than 3 mph
(5 km/h).

Note:

Some MyKey menu options only

appear if MyKey is enabled and at least one
MyKey is programmed.

E204495

This icon gives you the ability to
switch a feature on or off. A
check in the box indicates the

feature is on, and unchecked indicates the
feature is off.

Information Display Controls
(Type 1 and 2)

•

Press the up and down arrow buttons
to scroll through and highlight the
options within a menu.

•

Press the right arrow button to enter a
sub-menu.

•

Press the left arrow button to exit a
menu.

•

Press the OK button to choose and
confirm a setting or messages.

Type 1

Main Menu

Trip 1

Trip 2

Fuel Economy

Driver Assist

Settings

Trip 1

Digital Speed

Trip Odometer

Trip Timer

DTE

Average Fuel

Outside Temp

•

Digital Speed - Shows a digital display of your vehicle speed.

•

Trip Odometer - Registers the distance of individual trips.

•

Trip Timer - Registers the time of individual trips.

•

DTE - Shows the approximate distance your vehicle can travel before running out of
fuel.

•

Average Fuel - Shows the average fuel economy for a given trip.

•

Outside Temp - Shows the outside air temperature.

Note:

Press and hold OK to reset values.

Note:

Trip 2 information is the same as Trip 1.

Fuel Economy

Distance to E

Instant Fuel Economy

Average Fuel Economy

Average Speed

Auto StartStop

•

Distance to E - Shows the approximate distance your vehicle can travel before running
out of fuel.

•

Instant Fuel Economy - Shows your instantaneous fuel usage.

•

Average Fuel Economy - Shows the average fuel usage based on time.

•

Average Speed - Shows the average speed the vehicle has driven.

•

Auto StartStop - Shows the Auto StartStop status.

Note:

Press and hold OK to reset values.