Ford Bronco (1996 year). Manual - part 46

 

  Index      Ford     Ford Bronco - service manual 1996 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  44  45  46  47   ..

 

 

Ford Bronco (1996 year). Manual - part 46

 

 

184
With the 5-speed transmission you can engage R
(Reverse) only by moving the gearshift from the
left of 3 (Third) and 4 (Fourth) gears before you
shift into R (Reverse). This is a special lockout
feature that protects you from accidentally
shifting into R when you downshift from 5
(Fifth) gear.
5.
Once R (Reverse) is engaged, slowly release
the clutch pedal from the floor.
If R (Reverse) is not engaged, continue to push
the clutch pedal in while you put the gearshift
back into Neutral. Then, release the clutch pedal
for a moment and repeat steps 2 through 5.
Upshifting/downshifting
Upshift and Downshift at the speeds that are
specified in the charts available for your engine
and transmission.
185
Recommended Shift Speeds
5.0L EFI Engine with 5-Speed Manual
Overdrive Transmission
B
When you slow down or climb a steep hill,
always downshift before the engine starts to lose
power. Downshifting reduces the chance of
stalling and gives your vehicle better acceleration
to increase speed again.
186
When you drive down steep hills, downshifting
helps you keep a safe speed and helps prevent
unnecessary wear on the brakes.
When you come to a stop, do not downshift
through each gear. Disengage the clutch and use
the brake as necessary. Downshifting through
the gears decreases your vehicle’s fuel economy.
R
WARNING
Continued use of a damaged or worn
clutch, prolonged clutch slippage or
downshifting at excessive speeds can
result in a failure of the engine,
transmission or clutch components.
Transmission Function
Upshift at the speeds specified in the chart
available for your engine and transmission. All
forward gears are synchronized allowing you to
shift into them with your vehicle in motion. The
clutch pedal should be fully depressed when
shifting.
NOTE:
Shifting during extremely low rpm’s
can result in a momentary audible
rattle which disappears as vehicle
rpm’s are increased. Shifting at higher
speeds will eliminate this sound.
Parking
To park your vehicle, apply the service brake
pedal, and shift into N (Neutral) while still
maintaining pressure on the service brake. Set
the parking brake fully. Shift into first and turn
off the ignition.
187
R
WARNING
Do not park your vehicle in Neutral, it
may move unexpectedly and injure
someone. Use 1 (First) gear and set the
parking brake fully.
When the transfer case is in the N (Neutral)
position, the engine and transmission are
disconnected from the rest of the driveline.
Therefore, the vehicle is free to roll even if the
automatic transmission is in P (Park) or the
manual transmission is in gear.
R
WARNING
Do not leave the vehicle unattended with
the transfer case in the N (Neutral)
position. Always set the parking brake
fully and turn off the ignition when
leaving the vehicle.
Steering Your Vehicle
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.

 

 

 

 

 

 

 

Content   ..  44  45  46  47   ..