|
|
|
164
Electronic Stereo Radio with Cassette
165
How to tune radio stations (Stereo Radio)
There are three ways for you to tune in to a
particular station. You can manually locate the
station by using the “TUNE” button, “SEEK” the
station or select the station by using the memory
buttons, which you can set to any desired
frequency.
How to tune radio stations (Stereo Cassette
Radio)
There are four ways for you to tune in to a
particular station. You can manually locate the
station by using Automatic Music Search
(“AMS”), “SEEK” the station, “SCAN” to the
station or select the station by using the memory
buttons, which you can set to any desired
frequency.
❑
Using the “TUNE” function
You can change the frequency up or down
one increment at a time by pressing and
releasing either the right (+) or left (-) side of
the “TUNE” button. To change frequencies
quickly, press and hold down either the right
or left side of the “TUNE” button.
Manual tuning adjusts your radio to any
allowable broadcast frequency, whether or
not a station is present on that frequency.
(See
All About Radio Frequencies
in this
section.)
166
❑
Using the “AMS” function to manually tune
your radio (Stereo Cassette Radio)
You can change the frequency up or down
one increment at a time by first pressing the
“AMS” button (display shows “TUNE”) then
within approximately five seconds pressing
and releasing either the right (
a
) or left (
b
)
side of the “SEEK” button. To change
frequencies quickly, press and
hold down
either the right or left side of the “SEEK”
button.
❑
Using the “SEEK” function
This feature on your radio allows you to
automatically select listenable stations up or
down the frequency band. Press the right
(
a
) side of the “SEEK” button to select the
next listenable station up the frequency band.
Press the left (
b
) side of the button to select
the next listenable station down the
frequency band. By holding the button down,
listenable stations can be passed over to reach
the desired station.
❑
Using the “SCAN” function (Stereo Cassette
Radio)
Press the “SCAN” button to enter the scan
mode. The radio will begin scanning up the
frequency band, stopping on each listenable
station for approximately a five-second
sampling. This continues until you press the
“SCAN” button a second time. The display
flashes “AM” or “FM.”
❑
Setting the Station Memory Preset buttons
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
preset FM stations (5 in FM1 and 5 in FM2).
167
Follow the easy steps below to set these buttons
to the desired frequencies:
1.
Select a band, then select a frequency.
2.
Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
3.
Follow the two steps above for each station
memory preset button you want to set.
NOTE:
If the vehicle’s battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
Adjusting the tone balance and speaker
output of your radio
Push the “AUDIO” button repeatedly until
the display reads “BASS.” Push the right (+)
side of the “VOLUME” button to increase
bass (more “lows”), and push the left (-) side
to decrease bass (less “lows”).
❑
Increasing or decreasing treble response
Push the “AUDIO” button repeatedly until
the display reads “TREB.” Push the right (+)
side of the “VOLUME” button to increase the
treble (more “highs”), and push the left (-)
side to decrease treble (less “highs”).
|
|
|