|
|
|
144
Zone map
2.
Press and hold the “MODE” button until the
“VAR” indicator appears in the display
(approximately 4 seconds).
3.
Release the “MODE” button. The display
will now show the current zone number that
is stored in the compass.
4.
Press the “MODE” button repeatedly (or
press and hold in) until the desired zone
number appears in the display (once it
reaches 15, the next press of the button will
set it to 1).
5.
Release the “MODE” button when the
desired zone number is displayed.
After approximately three seconds the display
will flash all segments and then return to normal
operation. Zone is now updated.
145
Calibration adjustment
1.
Find an open area that is free from steel
structures and high voltage lines. An open
parking lot is a good example.
2.
Press and hold the “MODE” button until the
“CAL” indicator appears in the display
(approximately 8 seconds).
NOTE:
You cannot perform calibration unless
the display reads “CAL.”
3.
Release the “MODE” button.
4.
Once the “CAL” indicator has appeared,
drive the vehicle slowly (less than 3 mph /
5 km/h) in 360˚ circles until the “CAL”
indicator turns off. This will happen within 2
to 3 complete circles.
Map lamps
The map lamps are located in the overhead
console. The driver and passenger side each has
its own switch.
Map lamps — Eddie Bauer only
146
Storage Compartment
The storage compartment can be accessed by
pushing the “OPEN” button. The door will open
approximately one inch then it can be manually
moved to the full open position.
The compartment can be used to store a variety
of items such as: tissues, parking pass, cigarettes
or sunglasses.
Use as Garage Door Opener
The door can be converted from “Utility”
storage to a housing and means of actuating a
variety of “aftermarket” garage door opener
transmitters.
Removal of storage clip
In order to convert the door, simply remove the
utility storage clip from the back side of the
door as shown in the following illustration.
147
Installing “aftermarket” transmitter
Place the piece of Velcro hook onto your
aftermarket transmitter, opposite side as that of
the actuator button.
Place the transmitter into the console housing,
button down, as shown. Place the height
adapters provided into the back side of the
“GARAGE” button as needed. Some larger
transmitters will not need the adapters, and
some smaller ones may need two adapters.
The transmitter can now be activated without
opening the door. Simply depress the
“GARAGE” button.
|
|
|